- Introduction
- Maintenance
- Preparation
- Service specifications
- Diagnostics
- 2JZ-GE Engine
- 2JZ-GTE Engine
- 2JZ-GTE Turbocharging
- 2JZ-GE Emission control
- 2JZ-GTE Emission control
- 2JZ-GE SFI
- 2JZ-GTE SFI
- Cooling
- Lubrication
- Ignition system 2JZ-GE
- Ignition system 2JZ-GTE
- Starting system
- Charging system
- Clutch
- W58 manual transmission
- V160 manual transmission
- A340E 2JZ-GE automatic transmission
- A340E 2JZ-GTE automatic transmission
- Propeller shaft
- Suspension and axle
- Brake system
- Steering
- Supplemental restraint system
- Body electrical system
- Body
- Air conditioning system
Observe the following for safety reasons:
- Before using the OBDII scan tool or TOYOTA hand-held tester, the OBDII scan tool’s instruction book or TOYOTA hand-held tester’s operator manual should be read thoroughly.
- Be sure to route all cables securely when driving with the OBDII scan tool or TOYOTA hand-held tester connected to the vehicle. (i.e. Keep cables away from feet, pedals, steering wheel and shift lever.)
- Two persons are required when test driving with the OBDII scan tool or TOYOTA hand-held tester, one person to drive the vehicle and one person to operate the OBDII scan tool or TOYOTA hand-held tester.
This guide is based on the book edition Toyota (RM502U, 1997)
