- Introduction
- Maintenance
- Preparation
- Service specifications
- Diagnostics
- 2JZ-GE Engine
- 2JZ-GTE Engine
- 2JZ-GTE Turbocharging
- 2JZ-GE Emission control
- 2JZ-GTE Emission control
- 2JZ-GE SFI
- 2JZ-GTE SFI
- Cooling
- Lubrication
- Ignition system 2JZ-GE
- Ignition system 2JZ-GTE
- Starting system
- Charging system
- Clutch
- W58 manual transmission
- V160 manual transmission
- A340E 2JZ-GE automatic transmission
- A340E 2JZ-GTE automatic transmission
- Propeller shaft
- Suspension and axle
- Brake system
- Steering
- Supplemental restraint system
- Body electrical system
- Body
- Air conditioning system
- For vehicles with mobile communication systems such as two-way radios and cellular telephones, observe the following precautions.
- Install the antenna as far as possible away from the ECU and sensors of the vehicle’s electronic system.
- Install the antenna feeder at least 20 cm (7.87 in.) away from the ECU and sensors of the vehicle’s electronics systems. For details about ECU and sensors locations, refer to the section on the applicable component.
- Do not wind the antenna feeder together with the other wiring. As much as possible, also avoid running the antenna feeder parallel with other wire harnesses.
- Confirm that the antenna and feeder are correctly adjusted.
- Do not install powerful mobile communications system.
This guide is based on the book edition Toyota (RM502U, 1997)
